Fluke 810QDC Quick Disconnect Cable for the Fluke 810.
Previous product
Back to products
Fluke 805ES - EXTERNAL VIBRATION SENSOR
$2,080.00
Excluding GST 10%
Next product
Fluke 810PA Power Adapter with international plug set for the 810
$166.00
Excluding GST 10%
Fluke 810 Vibration Tester – Quick Disconnect Cable
$293.00Excluding GST 10%
Available on backorder
Related products
Close
Fluke TL222 Test Leads
Features
- Designed to improve steadiness in slippery hands
- Rubber overmolded surfaces and finger-hugging curves
- Reinforced strain relief
- CAT IV 600V & CAT III 1000V safety rating
- 10A rating
- UL listed
- 1-year warranty
Close
Fluke TP80 Electronic Test Probes
Fluke TP80 Offers
- One pair (red, black)
- IC insulated cap prevents shortening of IC legs for probing high density components or boards
- CAT III 1000 V, 10 A rating. UL listed
- One year warranty
Close
Fluke TL26A Test Lead Set
Product Features:
- U-shaped nose for blade-shaped terminals
- Notched jaw for gripping screw heads, bare wire or terminals
- Serrated teeth for gripping threaded or wire-wrapped terminals
- Cluster of sharp needles for piercing small gauge wires (#22-#28 AWG)
- Large piercing needle for penetrating larger gauge wires
Close
AC288 Terminal Block Probe with Retractable Probe Tip
Key features
- Retractable probe tip designed for increased safety, while providing flexibility to reach deep connection points
- Recommended for use with TL224, TL222 or TL221 Test Leads
- 11.5 cm (4.5 in) insulated, flexible shaft
- 1 mm diameter probe tip extends out to 8.4 mm (0.33 in) length
- Retractable probe tip is made with stainless steel
- Safety rated: IEC 61010-031 Ed.1.12008, CAT III 1000 V, CAT IV 600 V
- Operating temperature: -20 °C to 55 °C (-4 °F to 131 °F), 90% RH
- One-year warranty
Close
Fluke TL75 Hard Point Test Lead Set
Product Features:
- Comfort grip probes
- 48 in. PVC insulated test leads with right-angle shrouded banana plugs
- Recommended for general purpose measurements
- Safety rating(s): CAT II 1000V, 10A; CAT IV 600V, CAT III 1000V only with protective cap
- CSA listed
Close
Fluke AC89 Piercing Test Clip
Product Features:
- Single probe pierces 0.25 to 1.5 mm insulated wire
- Small pin allows self-healing of insulation
- Safety rating(s): CAT IV 600V, CAT III 1000V, 5A rating
- UL listed
Close
Fluke TL175 TwistGuard Test Leads
Features
- Extra-heavy duty strain relief on probe and plug
- Tested beyond 30,000 bends without failure
- -4 to 131°F (-20 to 55°C) operating temp
- Altitude of 6562ft (2000m)
- CAT II 1000V, CAT III 1000V, CAT IV 600V rated
- 10A max, Pollution Degree 2
- Conforms to EN61010-031
- 1-year warranty
Close
Fluke TL76 Test Lead Set
Features
- Removable, insulated IC caps allow probing on closely spaced leads and compliance with GS38
- CAT II 1000 V, 10 A rating
- CAT III 1000 V, CAT IV 600V only with protective cap
