Previous product
Back to products
Fluke Amprobe 30XR-A Auto Ranging Digital Multimeter with VolTect
$219.00
Excluding GST 10%
Next product
Fluke Amprobe 34XR-A TRMS Digital Multimeter with Temperature
$324.00
Excluding GST 10%
Fluke Amprobe 33XR-A Digital Multimeter with Temperature
$265.00Excluding GST 10%
-
Product Features:
- Frequency To 40 MHz, Temperature To 1832 F, Capacitance To 4000 microF
- Input Warning Tone When Test Leads Are In Wrong Jack
- 1000V/750V DC/AC
- 10 Amps AC/DC. Fully Safety Fused
- Resistance To 4ohm
- Min/max, relative, peak and data hold
- Auto power off to save battery life
- Separate door for easy battery and fuse access
- Magne-Grip Holster with magnetic hanging strap
- Display: 3-3/4 digit LCD, 3999 counts with 41-segment analog bar graph
- Display update rate: 2/sec, nominal
- Analog bar graph
- Overrange indication
- Operating temperature: 0 °C to 45 °C at < 70 % R.H.
- Storage temperature: -20 °C to 60 °C,
- Input warning tone when test leads are in wrong jack
Available on backorder
SKU: 2727788
Category: Amprobe - Test Instruments
Related products
Fluke Amprobe AC68C TRMS 600 A Clamp Meter
$667.00
Excluding GST 10%
- 8 functions/11 ranges
- Data and AC peak hold
- DC auto zero
- Carrying case included
- 33⁄4 digit, LCD, max reading of 3999
- Maximum jaw opening 1.57˝ (40 mm)
- Autoranging for frequency measurement
- Low battery indication
- Auto-power off after 30 minutes
- Manual function and range selection with rotary selector
Fluke Amprobe ACD-14 TRMS-PLUS Dual Display Digital Clamp Multimeter
$523.00
Excluding GST 10%
-
Product Features:
- Dual displays allow for simultaneous reading of amperage and voltage
- True-RMS for precise measurement results
- Thin jaws facilitate access in tight measurement spaces
- AC current to 600A
- AC and DC voltage to 600V
- Resistance to 40MΩ
- Capacitance to 3000 µF
- Temperature measurement with K-type thermocouple probe
- Frequency measurement
- In rush current measurement
- Diode test and continuity buzzer
- Micro Amps measurement for testing flame sensors
- Hold and maximum reading functions
- Accommodates conductors up to 28 mm (1.1″) in diameter
- Auto ranging instantly selects correct range
- Auto power off and low battery indication
- Rubber over-molded case
Fluke Amprobe ACD-10 PLUS 600A Clamp Multimeter
$343.00
Excluding GST 10%
Amprobe ACD-10 PLUS 600A Clamp Multimeter
- Measures AC and DC voltage to 600V and AC current to 600A to handle residential/commercial and small industrial applications
- Thin jaws, only 10mm (0.4″) thick make it easier to maneuver between tightly packed conductors
- Measures frequency, resistance, and capacitance
- Features continuity beeper to quickly find opens and shorts
- Accommodates conductors up to 1.0″ (25mm) in diameter
- Auto ranging saves time by instantly selecting correct range
- Auto power off to conserve battery life
- Rubber over-molded case absorbs shock
- Includes test leads, battery (installed), soft carrying pouch, and users manual
Fluke Amprobe AD40B Mini-Clamp Ammeter
$204.00
Excluding GST 10%
-
Product Features:
- Low-cost, miniature digital ammeter
- 400 A AC range
- Maximum jaw opening: 25.4 mm
- 4000-count display with bargraph
- Autoranging
- Data hold
- Auto-off
- 3 3/4 digit LCD (max reading 3999);
- Overrange indication: “OL indicated
- Power supply: two (2) 1.5V AAA batteries
Fluke Amprobe ACDC-3400 IND AC/DC CAT IV TRMS Clamp Meter
$1,299.00
Excluding GST 10%
- True-rms sensing increases measurement accuracy in noisy environments
- Measures AC/DC current up to 1000 A, AC voltage to 1000 V and DC voltage to 750 V, frequency, resistance, and capacitance and duty cycle
- Peak hold checks transients and motor start currents for spikes
- Relative zero displays the difference between the actual reading and a stored reference value and may be used with any function or range
- Audible continuity helps quickly identify opens and shorts
- Auto and manual ranging for measurement speed and flexibility
- Data hold holds the reading on the display for further analysis
- Diode test quickly finds voltage drops
- Accommodates conductors up to 2″ (51 mm) in diameter
- Safety rated to CAT IV 600 V and CAT III 1000 V
- Auto power off conserves battery life
- Backlight makes it easy to read even in dark conditions
Fluke Amprobe 15XP-B Digital Multimeter VolTect
$209.00
Excluding GST 10%
- Features
- The 15XP-B is the right choice for electronics engineers, technicians and field service
- Autoranging display for faster measurements
- TTL logic test for digital circuits
- Integrated tilt stand for easy bench use
- Diode test for component level troubleshooting
- Data Hold freezes display to “hold” measurement reading
- 750 V AC / 1000 V DC—highest voltage rating in this size of meter
- Special 2000M Ω measurement range
- Battery Life: 200 hours typical with carbon-zinc
- Size: (H x W x D) 155 mm x 72 mm x 32 mm (6.1 x 2.83 x 1.26 IN)
- Safety: CAT II 1000V, CATIII 600V, CE, N10140
Amprobe ACD-53NAV CAT IV 1000 A AC True-rms Navigator Clamp Meter
$870.00
Excluding GST 10%
- True RMS technology improves accuracy in noisy environments
- Measures AC/DC voltage to 1000 V, AC/DC current to 600 A, plus resistance, frequency, capacitance, power and power factor, total harmonics distortion (THD) and individual harmonics from 1 to 25
- Includes inrush current measurement and phase rotation indication for 3-phase motors
- Non-contact voltage detection enhances safety
- Low pass filter enables measuring voltage and frequency on variable frequency drives
- Continuity beeper quickly identifies shorts and opens
- Large backlit digital display with analog bar graph presents the full picture
- Min, max and smart data hold
- Peak hold identifies spikes and transients
- In-jaw flashlight automatically lights when jaws open to illuminate dark panels and junction boxes
- Auto power off conserves battery life
- Maximum jaw opening accommodates large conductors up to 1.45″ (37 mm)
- Rubber overmold body absorbs shocks—drop proof to 4 feet (1.2 m)
- CAT IV-rated AC/DC current clamp meter
Fluke Amprobe 37XR-A TRMS Digital Multimeter
$444.00
Excluding GST 10%
- Backlight, True-rms with component and logic test
- Inductance to 40 H, frequency to 40 MHz, capacitance to 400 μF, logic to 20 MHz
- Input warning tone when test leads are in wrong jack
- 10 Amps AC/DC, fully safety fused
- Continuity beeper
- Min/max, average, relative, peak, and data hold
- Auto power off to save battery life
- Separate door for easy battery and fuse access
- Magne-Grip™ Holster with magnetic hanging strap
- Autoranging; display: 4-3/4 digit LCD, 10,000 counts with 41-segment analog bar graph
- Display Update Rate: 2/sec, nominal
- Power Battery: 9 V NEDA 1604, JIS 006P, IEC 6F22
- Operating temperature: 0 °C to 45 °C at < 70 % R.H