Previous product
Back to products
Amprobe NCV-1040 Non-Contact Voltage Probe
$92.00
Excluding GST 10%
Next product
Fluke Amprobe PM55A Pocket Multimeter with VolTect™ Non-Contact Voltage Detection
$179.00
Excluding GST 10%
Amprobe PM51A Pocket Digital Multimeter
$81.00Excluding GST 10%
- Measures AC and DC voltage, resistance, continuity with beeper, capacitance and frequency
- Fully autoranging with 7 measurement functions and 27 ranges
- Large oversize digital display with measurement results and the unit icon
- Data hold freezes measurement value
- Average sensing
- Power consumption (typical) 2 mA
- Automatic power off (idle for 30 minutes)
- APO consumption (typical) 2.2 μA
- E.M.C. meets EN61326
- Audible continuity tester open circuit voltage 0.4 V DC typical
- Diode tester test current (typical) 0.25 mA
- Diode tester open circuit voltage 1.6 V DC
Available on backorder
Category: Amprobe - Test Instruments
Related products
Fluke Amprobe 15XP-B Digital Multimeter VolTect
$209.00
Excluding GST 10%
- Features
- The 15XP-B is the right choice for electronics engineers, technicians and field service
- Autoranging display for faster measurements
- TTL logic test for digital circuits
- Integrated tilt stand for easy bench use
- Diode test for component level troubleshooting
- Data Hold freezes display to “hold” measurement reading
- 750 V AC / 1000 V DC—highest voltage rating in this size of meter
- Special 2000M Ω measurement range
- Battery Life: 200 hours typical with carbon-zinc
- Size: (H x W x D) 155 mm x 72 mm x 32 mm (6.1 x 2.83 x 1.26 IN)
- Safety: CAT II 1000V, CATIII 600V, CE, N10140
Fluke Amprobe 33XR-A Digital Multimeter with Temperature
$265.00
Excluding GST 10%
-
Product Features:
- Frequency To 40 MHz, Temperature To 1832 F, Capacitance To 4000 microF
- Input Warning Tone When Test Leads Are In Wrong Jack
- 1000V/750V DC/AC
- 10 Amps AC/DC. Fully Safety Fused
- Resistance To 4ohm
- Min/max, relative, peak and data hold
- Auto power off to save battery life
- Separate door for easy battery and fuse access
- Magne-Grip Holster with magnetic hanging strap
- Display: 3-3/4 digit LCD, 3999 counts with 41-segment analog bar graph
- Display update rate: 2/sec, nominal
- Analog bar graph
- Overrange indication
- Operating temperature: 0 °C to 45 °C at < 70 % R.H.
- Storage temperature: -20 °C to 60 °C,
- Input warning tone when test leads are in wrong jack
Fluke Amprobe AD40B Mini-Clamp Ammeter
$204.00
Excluding GST 10%
-
Product Features:
- Low-cost, miniature digital ammeter
- 400 A AC range
- Maximum jaw opening: 25.4 mm
- 4000-count display with bargraph
- Autoranging
- Data hold
- Auto-off
- 3 3/4 digit LCD (max reading 3999);
- Overrange indication: “OL indicated
- Power supply: two (2) 1.5V AAA batteries
Fluke Amprobe ACD-14 PLUS Dual Display Clamp Multimeter with Temperature
$343.00
Excluding GST 10%
-
Product Features:
- Dual displays permit simultaneous reading of amps and volts
- Measurement ranges include:
- AC current to 600A
- AC and DC voltage to 600V
- Capacitance to 3000 µF
- Resistance to 40MΩ
- Frequency to 40kHz
- Measures temperature with included K-type thermocouple probe
- Includes micro amps measurement for testing flame sensors
- Diode test quickly finds voltage drops
- Continuity beeper detects opens and shorts
- Autoranging feature instantly selects correct range
- Hold and maximum reading functions
- Thin jaws make it easier to access conductors in tight spaces
- Accommodates conductors up to 25 mm (1.0″) in diameter
- Auto power off and low battery indication help extend battery life
- Rubber, over-molded case absorbs shock
Fluke Amprobe ACDC-100 1000 A AC/DC Clamp Meter
$343.00
Excluding GST 10%
- Large, easy to read LCD display
- Auto and manual ranging
- Relative zero mode
- Auto power off
- Data hold
- MAX capture function for inrush current measurements (30 mS response)
- Diode test
- Audible continuity
- Accommodates conductors up to 2.0″ (50 mm) in diameter
- “Third hand” – test probe holder
- Rubber over-molded case with built-in probes storage
Fluke Amprobe ACD-6 PRO Digital Clamp Meter 600 V AC/DC
$285.00
Excluding GST 10%
-
Product Features:
- AC current to 1000A
- AC and DC voltage to 600V
- Resistance
- Continuity beeper
- Diode test
- Relative zero mode
- Auto and manual ranging
- Auto power off
- Data hold
- Large, easy to read LCD display
- Accommodates conductors up to 1.77″ (45mm) in diameter
Amprobe ALC-110 Leakage Current Clamp
$1,098.00
Excluding GST 10%
-
Product Features:
- Measures:
- Earth and differential leakage currents
- Leakage currents through the earth (PE) conductor
- Appliance current consumption without interruptions to the circuit
- Low influence of external low frequency magnetic fields: @ IN: 3.500 mA – 600.0 mA ≤ 30 A/m, operating class 2
- True-RMS measurements for accuracy when measuring complex, non-sinusoidal waveforms
- Mechanical jaw lock with 1.2 in. (30 mm) opening assures accuracy of low current measurements
- Highest resolution of 0.001 mA while measuring up to 60 A
- Broad frequency range 15 Hz to 1 kHz
- Selectable filters:
- Low Pass 50/60Hz filter to perform measurements on equipment driven by Variable Frequency Drives (VFDs) or affected by high frequency noise
- Appliance Filter to conduct leakage current measurements on appliances
- No filter
- Selectable limits: 0.25 mA, 0.5 mA, 3.5 mA, 10 mA, 12 mA
- Max readings and hold function
- High safety rating: CAT III 600 V
- Battery-saving design with an auto backlight off and auto power off
Applications
- Trace the source of earth leakage current
- Identify intermittent GFCI trips without switching equipment off
- Check a system for an electrical break of insulation where current is flowing to the ground
- Where industrial leakage current testing is required
- Measures:
Fluke Amprobe ACD-10 PLUS 600A Clamp Multimeter
$343.00
Excluding GST 10%
Amprobe ACD-10 PLUS 600A Clamp Multimeter
- Measures AC and DC voltage to 600V and AC current to 600A to handle residential/commercial and small industrial applications
- Thin jaws, only 10mm (0.4″) thick make it easier to maneuver between tightly packed conductors
- Measures frequency, resistance, and capacitance
- Features continuity beeper to quickly find opens and shorts
- Accommodates conductors up to 1.0″ (25mm) in diameter
- Auto ranging saves time by instantly selecting correct range
- Auto power off to conserve battery life
- Rubber over-molded case absorbs shock
- Includes test leads, battery (installed), soft carrying pouch, and users manual