Previous product
Back to products
Amprobe AT-8020 Advanced Industrial Wire Tracer Kit
$2,634.00
Excluding GST 10%
Next product
Fluke Amprobe BAT-200 Battery Tester
$28.00
Excluding GST 10%
Amprobe CT-400 Signal Clamp
$622.00Excluding GST 10%
-
Product Features:
- Used to induce a signal into wires without access to bare conductors
- For use with wire tracers and kits
- Operating voltage: 0 to 1000 V AC
- Operating frequency: Wire tracing: 32.768 kHz / AC current measurement: 45 Hz to 400 Hz
- Use the CT-400 Signal Clamp with the AT-6000-T to induce signal into wires when there is no access to bare conductors
- CAT IV 600 V, CAT III 1000 V
Available on backorder
SKU: 4868025
Category: Amprobe - Test Instruments
Related products
Fluke Amprobe ACD-23SW Swivel Clamp Meter
$563.00
Excluding GST 10%
-
Product Features:
- Performs true-RMS measurement
- 180 degree rotating head for optimal display viewing
- Advanced VoltTect non-contact voltage detection
- Easy to use with slim jaw design and one hand operation
- Measures AC current up to 400A
- Measures AC and DC voltage up to 600V
- Resistance and capacitance measurement
- Audible continuity
- Temperature measurement with type-K thermocouple probe
- Auto and manual ranging respectively offer quick checks and precise measurements
- Accommodates conductors up to 1.18″ (30mm) in diameter
- Auto power off to extend battery life
- Includes data hold function
- Safety rated toCAT III 600 V
Fluke Amprobe ACD-6 PRO Digital Clamp Meter 600 V AC/DC
$285.00
Excluding GST 10%
-
Product Features:
- AC current to 1000A
- AC and DC voltage to 600V
- Resistance
- Continuity beeper
- Diode test
- Relative zero mode
- Auto and manual ranging
- Auto power off
- Data hold
- Large, easy to read LCD display
- Accommodates conductors up to 1.77″ (45mm) in diameter
Fluke Amprobe ACDC-100 1000 A AC/DC Clamp Meter
$343.00
Excluding GST 10%
- Large, easy to read LCD display
- Auto and manual ranging
- Relative zero mode
- Auto power off
- Data hold
- MAX capture function for inrush current measurements (30 mS response)
- Diode test
- Audible continuity
- Accommodates conductors up to 2.0″ (50 mm) in diameter
- “Third hand” – test probe holder
- Rubber over-molded case with built-in probes storage
Fluke Amprobe ACDC-100 TRMS 1000 A AC/DC Clamp Meter
$485.00
Excluding GST 10%
Product Features:
- Performs True-RMS measurements for accuracy
- Measures AC current to 800A and DC current to 1000A
- Measures AC and DC voltage to 600V
- Capacitance and resistance measurements
- Continuity beeper quickly identifies shorts and opens
- Relative zero mode displays difference between actual reading and stored reference value
- Data hold freezes reading on display for further analysis
- Diode test quickly finds voltage drops
- MAX capture function measures inrush current (30 mS response)
- Easy to read backlit digital display
- Auto power-off to conserve battery life
- Equipped with “third hand” test probe holder
- Rubber over-molded case absorbs shock and provides built-in probe storage
- Accommodates conductors up to 2.0″ (50mm) in diameter
- CAT III 600V rated
Fluke Amprobe 33XR-A Digital Multimeter with Temperature
$265.00
Excluding GST 10%
-
Product Features:
- Frequency To 40 MHz, Temperature To 1832 F, Capacitance To 4000 microF
- Input Warning Tone When Test Leads Are In Wrong Jack
- 1000V/750V DC/AC
- 10 Amps AC/DC. Fully Safety Fused
- Resistance To 4ohm
- Min/max, relative, peak and data hold
- Auto power off to save battery life
- Separate door for easy battery and fuse access
- Magne-Grip Holster with magnetic hanging strap
- Display: 3-3/4 digit LCD, 3999 counts with 41-segment analog bar graph
- Display update rate: 2/sec, nominal
- Analog bar graph
- Overrange indication
- Operating temperature: 0 °C to 45 °C at < 70 % R.H.
- Storage temperature: -20 °C to 60 °C,
- Input warning tone when test leads are in wrong jack
Fluke Amprobe ACD-50NAV CAT IV 600 A TRMS Navigator Clamp Meter
$679.00
Excluding GST 10%
-
Product Features:
- True-RMS technology improves accuracy in noisy environments
- Measures AC/DC voltage to 1000V and AC current to 600A
- Measures resistance, frequency and capacitance
- Measures power factor, total harmonics distortion (THD) and individual harmonics from 1 to 25
- Includes inrush current measurement and phase rotation indication for 3-phase motors
- Non-contact voltage detection enhances safety
- Low pass filter allows measurement of voltage and frequency for variable frequency drives
- Continuity beeper quickly identifies shorts and opens
- Large 1000 count display with active backlight and analog bar graph
- Min, max, and smart data hold
- Peak hold identifies spikes and transients
- In-jaw flashlight automatically lights when jaws open, illuminating dark panels and junction boxes
- Auto power off conserves battery life
- Maximum jaw opening accommodates conductors up to 1.45″ (37mm)
- Rubber overmold body absorbs shocks: drop proof to 4 ft. (1.2m)
- Meets CAT IV 600V /CAT III 1000V safety standard
Fluke Amprobe 30XR-A Auto Ranging Digital Multimeter with VolTect
$219.00
Excluding GST 10%
-
Product Features:
- Non-contact voltage detector
- Separate door for easy battery and fuse access
- Manual ranging; display: 3-1/2 digit LCD, 1999 counts
- Display update rate: 2.5/sec, nominal
- Power battery: 9 V NEDA 1604, JIS 006P, IEC 6F22
- Operating temperature: 0 °C to 45 °C at < 70 % R.H.
- Storage temperature: -20 °C to 60 °C, 0 to 80 % R.H. with battery removed from meter
- Low battery indication
- Overrange indication
- Min/max and data Hold
- 600V AC
- Magne-Grip Holster With Magnetic Hanging Strap
- 600V AC/DC
- 10 Amps AC/DC, Fully Safety Fused
- Continuity Beeper
Fluke Amprobe 37XR-A TRMS Digital Multimeter
$444.00
Excluding GST 10%
- Backlight, True-rms with component and logic test
- Inductance to 40 H, frequency to 40 MHz, capacitance to 400 μF, logic to 20 MHz
- Input warning tone when test leads are in wrong jack
- 10 Amps AC/DC, fully safety fused
- Continuity beeper
- Min/max, average, relative, peak, and data hold
- Auto power off to save battery life
- Separate door for easy battery and fuse access
- Magne-Grip™ Holster with magnetic hanging strap
- Autoranging; display: 4-3/4 digit LCD, 10,000 counts with 41-segment analog bar graph
- Display Update Rate: 2/sec, nominal
- Power Battery: 9 V NEDA 1604, JIS 006P, IEC 6F22
- Operating temperature: 0 °C to 45 °C at < 70 % R.H