Previous product
Back to products
Fluke Amprobe LH41A Low Current Clamp On Ammeter
$1,381.00
Excluding GST 10%
Next product
Fluke Amprobe LM-120 Light Meter
$449.00
Excluding GST 10%
Fluke Amprobe LM-100 Light Meter
$360.00Excluding GST 10%
-
Amprobe LM-100 Offers
Use this light meter to measure the illumination level in the interior and to switch off or reduce or increase the output level of lighting fixtures. Reduce the energy burden of the building by significantly increasing the efficiency of its lighting system.
One lux is the illumination for one candela lamp perpendicular to a surface one meter squared at a distance of one meter. One fc is the illumination from a one candela lamp perpendicular to a surface one foot squared at a distance of one foot.
Features
- 1 footcandle = 10.764 lux
- 1 lux – 0.09290 footcandles
- Measure in Lux or Footcandles, front panel switchable
- Measuring range to 20,000 Lux or Foot candle
- Silicon photodiode sensor and filter
- Data Hold to freeze reading on the digital display
- Min/Max ability to show high and low readings
- Large, 3-1/2 digit display
Available on backorder
SKU: 3052348
Category: Amprobe - Test Instruments
Related products
Amprobe ALC-110 Leakage Current Clamp
$1,098.00
Excluding GST 10%
-
Product Features:
- Measures:
- Earth and differential leakage currents
- Leakage currents through the earth (PE) conductor
- Appliance current consumption without interruptions to the circuit
- Low influence of external low frequency magnetic fields: @ IN: 3.500 mA – 600.0 mA ≤ 30 A/m, operating class 2
- True-RMS measurements for accuracy when measuring complex, non-sinusoidal waveforms
- Mechanical jaw lock with 1.2 in. (30 mm) opening assures accuracy of low current measurements
- Highest resolution of 0.001 mA while measuring up to 60 A
- Broad frequency range 15 Hz to 1 kHz
- Selectable filters:
- Low Pass 50/60Hz filter to perform measurements on equipment driven by Variable Frequency Drives (VFDs) or affected by high frequency noise
- Appliance Filter to conduct leakage current measurements on appliances
- No filter
- Selectable limits: 0.25 mA, 0.5 mA, 3.5 mA, 10 mA, 12 mA
- Max readings and hold function
- High safety rating: CAT III 600 V
- Battery-saving design with an auto backlight off and auto power off
Applications
- Trace the source of earth leakage current
- Identify intermittent GFCI trips without switching equipment off
- Check a system for an electrical break of insulation where current is flowing to the ground
- Where industrial leakage current testing is required
- Measures:
Fluke Amprobe 35XP-A Digital Multimeter with Temperature
$281.00
Excluding GST 10%
- Temperature measurement capability to 1000 °C/1832 °F (type-K thermocouple included)
- 600 V AC/600 V DC – highest voltage rating in this class of meter
- Capacitance for motor run/start test
- 0.1 μA resolution for flame sensor testing
- Frequency to 1 MHz
- Resistance to 40 MΩ
- Data hold freezes display
- Magne-Grip™ Holster
- VolTect™ non-contact voltage detector
- Low battery indication
Fluke Amprobe ACD-51NAV CAT IV 600 A TRMS Navigator Clamp Meter
$849.00
Excluding GST 10%
-
Product Features:
- True-RMS technology improves accuracy in noisy environments
- Measures AC/DC voltage to 1000V and AC current to 600A
- Resistance, frequency, and capacitance measurements
- Measures power factor, total harmonics distortion (THD) and individual harmonics from 1 to 25
- Provides DC micro amps measurements to test flame sensors
- Includes inrush current measurement and phase rotation indication for 3-phase motors
- Measures temperature from -58 to 1832°F (-50 to 1000°C)
- Non-contact voltage detection enhances safety
- Low pass filter enables measuring voltage and frequency for variable frequency drives
- Continuity beeper quickly identifies shorts and opens
- Large backlit digital display with analog bar graph
- Min, max and smart data hold
- Peak hold identifies spikes and transients
- In-jaw flashlight automatically lights when jaws open, illuminating dark panels and junction boxes
- Auto power off conserves battery life
- Maximum jaw opening accommodates large conductors up to 1.45″ (37mm)
- Rubber overmold body absorbs shocks: drop proof to 4 ft. (1.2m)
- Safety rated to CAT IV
Fluke Amprobe 33XR-A Digital Multimeter with Temperature
$265.00
Excluding GST 10%
-
Product Features:
- Frequency To 40 MHz, Temperature To 1832 F, Capacitance To 4000 microF
- Input Warning Tone When Test Leads Are In Wrong Jack
- 1000V/750V DC/AC
- 10 Amps AC/DC. Fully Safety Fused
- Resistance To 4ohm
- Min/max, relative, peak and data hold
- Auto power off to save battery life
- Separate door for easy battery and fuse access
- Magne-Grip Holster with magnetic hanging strap
- Display: 3-3/4 digit LCD, 3999 counts with 41-segment analog bar graph
- Display update rate: 2/sec, nominal
- Analog bar graph
- Overrange indication
- Operating temperature: 0 °C to 45 °C at < 70 % R.H.
- Storage temperature: -20 °C to 60 °C,
- Input warning tone when test leads are in wrong jack
Fluke Amprobe ACD-50NAV CAT IV 600 A TRMS Navigator Clamp Meter
$679.00
Excluding GST 10%
-
Product Features:
- True-RMS technology improves accuracy in noisy environments
- Measures AC/DC voltage to 1000V and AC current to 600A
- Measures resistance, frequency and capacitance
- Measures power factor, total harmonics distortion (THD) and individual harmonics from 1 to 25
- Includes inrush current measurement and phase rotation indication for 3-phase motors
- Non-contact voltage detection enhances safety
- Low pass filter allows measurement of voltage and frequency for variable frequency drives
- Continuity beeper quickly identifies shorts and opens
- Large 1000 count display with active backlight and analog bar graph
- Min, max, and smart data hold
- Peak hold identifies spikes and transients
- In-jaw flashlight automatically lights when jaws open, illuminating dark panels and junction boxes
- Auto power off conserves battery life
- Maximum jaw opening accommodates conductors up to 1.45″ (37mm)
- Rubber overmold body absorbs shocks: drop proof to 4 ft. (1.2m)
- Meets CAT IV 600V /CAT III 1000V safety standard
Fluke Amprobe ACDC-100 TRMS 1000 A AC/DC Clamp Meter
$485.00
Excluding GST 10%
Product Features:
- Performs True-RMS measurements for accuracy
- Measures AC current to 800A and DC current to 1000A
- Measures AC and DC voltage to 600V
- Capacitance and resistance measurements
- Continuity beeper quickly identifies shorts and opens
- Relative zero mode displays difference between actual reading and stored reference value
- Data hold freezes reading on display for further analysis
- Diode test quickly finds voltage drops
- MAX capture function measures inrush current (30 mS response)
- Easy to read backlit digital display
- Auto power-off to conserve battery life
- Equipped with “third hand” test probe holder
- Rubber over-molded case absorbs shock and provides built-in probe storage
- Accommodates conductors up to 2.0″ (50mm) in diameter
- CAT III 600V rated
Fluke Amprobe ACD-6 PRO Digital Clamp Meter 600 V AC/DC
$285.00
Excluding GST 10%
-
Product Features:
- AC current to 1000A
- AC and DC voltage to 600V
- Resistance
- Continuity beeper
- Diode test
- Relative zero mode
- Auto and manual ranging
- Auto power off
- Data hold
- Large, easy to read LCD display
- Accommodates conductors up to 1.77″ (45mm) in diameter
Fluke Amprobe 38XR-A TRMS Digital Multimeter with Temperature
$499.00
Excluding GST 10%
- Backlight, True-rms with with optical PC interface
- Frequency to 10 MHz,capacitance to 400 uF, temperature to 2372 °F
- Bright blue backlight
- 10 Amps AC/DC, fully safety fused
- Continuity beeper
- Min/max, average, relative, peak, and data hold
- Auto power off to save battery life
- Separate door for easy battery and fuse access
- Magne-Grip™ Holster with magnetic hanging strap
- Autoranging; display: 4-3/4 digit LCD, 10,000 counts with 41-segment analog bar graph
- Display update rate: 2/sec, nominal
- Power battery: 9 V NEDA 1604, JIS 006P, IEC 6F22
- Operating temperature: 0 °C to 45 °C at < 70 % R.H
- Input lead warning