“Fluke Amprobe ACDC-52NAV AC/DC CAT IV 600 A TRMS Navigator Clamp Meter” has been added to your cart. View cart
Previous product
Back to products
Fluke Amprobe LH41A Low Current Clamp On Ammeter
$1,381.00
Excluding GST 10%
Next product
Fluke Amprobe LM-120 Light Meter
$449.00
Excluding GST 10%
Fluke Amprobe LM-100 Light Meter
$360.00Excluding GST 10%
-
Amprobe LM-100 Offers
Use this light meter to measure the illumination level in the interior and to switch off or reduce or increase the output level of lighting fixtures. Reduce the energy burden of the building by significantly increasing the efficiency of its lighting system.
One lux is the illumination for one candela lamp perpendicular to a surface one meter squared at a distance of one meter. One fc is the illumination from a one candela lamp perpendicular to a surface one foot squared at a distance of one foot.
Features
- 1 footcandle = 10.764 lux
- 1 lux – 0.09290 footcandles
- Measure in Lux or Footcandles, front panel switchable
- Measuring range to 20,000 Lux or Foot candle
- Silicon photodiode sensor and filter
- Data Hold to freeze reading on the digital display
- Min/Max ability to show high and low readings
- Large, 3-1/2 digit display
Available on backorder
SKU: 3052348
Category: Amprobe - Test Instruments
Related products
Fluke Amprobe 30XR-A Auto Ranging Digital Multimeter with VolTect
$219.00
Excluding GST 10%
-
Product Features:
- Non-contact voltage detector
- Separate door for easy battery and fuse access
- Manual ranging; display: 3-1/2 digit LCD, 1999 counts
- Display update rate: 2.5/sec, nominal
- Power battery: 9 V NEDA 1604, JIS 006P, IEC 6F22
- Operating temperature: 0 °C to 45 °C at < 70 % R.H.
- Storage temperature: -20 °C to 60 °C, 0 to 80 % R.H. with battery removed from meter
- Low battery indication
- Overrange indication
- Min/max and data Hold
- 600V AC
- Magne-Grip Holster With Magnetic Hanging Strap
- 600V AC/DC
- 10 Amps AC/DC, Fully Safety Fused
- Continuity Beeper
Fluke Amprobe ACDC-100 1000 A AC/DC Clamp Meter
$343.00
Excluding GST 10%
- Large, easy to read LCD display
- Auto and manual ranging
- Relative zero mode
- Auto power off
- Data hold
- MAX capture function for inrush current measurements (30 mS response)
- Diode test
- Audible continuity
- Accommodates conductors up to 2.0″ (50 mm) in diameter
- “Third hand” – test probe holder
- Rubber over-molded case with built-in probes storage
Fluke Amprobe ACD-14 PLUS Dual Display Clamp Multimeter with Temperature
$343.00
Excluding GST 10%
-
Product Features:
- Dual displays permit simultaneous reading of amps and volts
- Measurement ranges include:
- AC current to 600A
- AC and DC voltage to 600V
- Capacitance to 3000 µF
- Resistance to 40MΩ
- Frequency to 40kHz
- Measures temperature with included K-type thermocouple probe
- Includes micro amps measurement for testing flame sensors
- Diode test quickly finds voltage drops
- Continuity beeper detects opens and shorts
- Autoranging feature instantly selects correct range
- Hold and maximum reading functions
- Thin jaws make it easier to access conductors in tight spaces
- Accommodates conductors up to 25 mm (1.0″) in diameter
- Auto power off and low battery indication help extend battery life
- Rubber, over-molded case absorbs shock
Fluke Amprobe ACDC-3400 IND AC/DC CAT IV TRMS Clamp Meter
$1,299.00
Excluding GST 10%
- True-rms sensing increases measurement accuracy in noisy environments
- Measures AC/DC current up to 1000 A, AC voltage to 1000 V and DC voltage to 750 V, frequency, resistance, and capacitance and duty cycle
- Peak hold checks transients and motor start currents for spikes
- Relative zero displays the difference between the actual reading and a stored reference value and may be used with any function or range
- Audible continuity helps quickly identify opens and shorts
- Auto and manual ranging for measurement speed and flexibility
- Data hold holds the reading on the display for further analysis
- Diode test quickly finds voltage drops
- Accommodates conductors up to 2″ (51 mm) in diameter
- Safety rated to CAT IV 600 V and CAT III 1000 V
- Auto power off conserves battery life
- Backlight makes it easy to read even in dark conditions
Fluke Amprobe AD40B Mini-Clamp Ammeter
$204.00
Excluding GST 10%
-
Product Features:
- Low-cost, miniature digital ammeter
- 400 A AC range
- Maximum jaw opening: 25.4 mm
- 4000-count display with bargraph
- Autoranging
- Data hold
- Auto-off
- 3 3/4 digit LCD (max reading 3999);
- Overrange indication: “OL indicated
- Power supply: two (2) 1.5V AAA batteries
Amprobe ALC-110 Leakage Current Clamp
$1,098.00
Excluding GST 10%
-
Product Features:
- Measures:
- Earth and differential leakage currents
- Leakage currents through the earth (PE) conductor
- Appliance current consumption without interruptions to the circuit
- Low influence of external low frequency magnetic fields: @ IN: 3.500 mA – 600.0 mA ≤ 30 A/m, operating class 2
- True-RMS measurements for accuracy when measuring complex, non-sinusoidal waveforms
- Mechanical jaw lock with 1.2 in. (30 mm) opening assures accuracy of low current measurements
- Highest resolution of 0.001 mA while measuring up to 60 A
- Broad frequency range 15 Hz to 1 kHz
- Selectable filters:
- Low Pass 50/60Hz filter to perform measurements on equipment driven by Variable Frequency Drives (VFDs) or affected by high frequency noise
- Appliance Filter to conduct leakage current measurements on appliances
- No filter
- Selectable limits: 0.25 mA, 0.5 mA, 3.5 mA, 10 mA, 12 mA
- Max readings and hold function
- High safety rating: CAT III 600 V
- Battery-saving design with an auto backlight off and auto power off
Applications
- Trace the source of earth leakage current
- Identify intermittent GFCI trips without switching equipment off
- Check a system for an electrical break of insulation where current is flowing to the ground
- Where industrial leakage current testing is required
- Measures:
Fluke Amprobe ACD-50NAV CAT IV 600 A TRMS Navigator Clamp Meter
$679.00
Excluding GST 10%
-
Product Features:
- True-RMS technology improves accuracy in noisy environments
- Measures AC/DC voltage to 1000V and AC current to 600A
- Measures resistance, frequency and capacitance
- Measures power factor, total harmonics distortion (THD) and individual harmonics from 1 to 25
- Includes inrush current measurement and phase rotation indication for 3-phase motors
- Non-contact voltage detection enhances safety
- Low pass filter allows measurement of voltage and frequency for variable frequency drives
- Continuity beeper quickly identifies shorts and opens
- Large 1000 count display with active backlight and analog bar graph
- Min, max, and smart data hold
- Peak hold identifies spikes and transients
- In-jaw flashlight automatically lights when jaws open, illuminating dark panels and junction boxes
- Auto power off conserves battery life
- Maximum jaw opening accommodates conductors up to 1.45″ (37mm)
- Rubber overmold body absorbs shocks: drop proof to 4 ft. (1.2m)
- Meets CAT IV 600V /CAT III 1000V safety standard
Fluke Amprobe ACD-51NAV CAT IV 600 A TRMS Navigator Clamp Meter
$849.00
Excluding GST 10%
-
Product Features:
- True-RMS technology improves accuracy in noisy environments
- Measures AC/DC voltage to 1000V and AC current to 600A
- Resistance, frequency, and capacitance measurements
- Measures power factor, total harmonics distortion (THD) and individual harmonics from 1 to 25
- Provides DC micro amps measurements to test flame sensors
- Includes inrush current measurement and phase rotation indication for 3-phase motors
- Measures temperature from -58 to 1832°F (-50 to 1000°C)
- Non-contact voltage detection enhances safety
- Low pass filter enables measuring voltage and frequency for variable frequency drives
- Continuity beeper quickly identifies shorts and opens
- Large backlit digital display with analog bar graph
- Min, max and smart data hold
- Peak hold identifies spikes and transients
- In-jaw flashlight automatically lights when jaws open, illuminating dark panels and junction boxes
- Auto power off conserves battery life
- Maximum jaw opening accommodates large conductors up to 1.45″ (37mm)
- Rubber overmold body absorbs shocks: drop proof to 4 ft. (1.2m)
- Safety rated to CAT IV