Fluke 810QDC Quick Disconnect Cable for the Fluke 810.
Previous product
Back to products
Fluke 805ES - EXTERNAL VIBRATION SENSOR
$2,080.00
Excluding GST 10%
Next product
Fluke 810PA Power Adapter with international plug set for the 810
$166.00
Excluding GST 10%
Fluke 810 Vibration Tester – Quick Disconnect Cable
$293.00Excluding GST 10%
Available on backorder
Related products
Close
Fluke H900 Test Lead Holder
Features
- Mounting holes for securing to wall or surface
- 10.98 x 3.5 x 1.26 inches (27.9 x 8.9 x 3.2 cm)
- 1-year warranty
Close
AC288 Terminal Block Probe with Retractable Probe Tip
Key features
- Retractable probe tip designed for increased safety, while providing flexibility to reach deep connection points
- Recommended for use with TL224, TL222 or TL221 Test Leads
- 11.5 cm (4.5 in) insulated, flexible shaft
- 1 mm diameter probe tip extends out to 8.4 mm (0.33 in) length
- Retractable probe tip is made with stainless steel
- Safety rated: IEC 61010-031 Ed.1.12008, CAT III 1000 V, CAT IV 600 V
- Operating temperature: -20 °C to 55 °C (-4 °F to 131 °F), 90% RH
- One-year warranty
Close
Fluke AC283 Pincer Clips
Features
- 1A rating
- Use for continuity testing on circuit board components
- 4.49in (11.4cm) flexible insulated shaft
- CAT IV 600V, CAT III 1000V safety rated
- UL listed
- 1-year warranty
Close
Fluke TL910 Electronic Test Probes
Product Features:
- 1 mm tips access hard to reach test points
- Probe tip length up to 100 mm
- Test lead length: 1 m
- 3 sets of spring loaded gold tips
- 2 sets of stainless steel tips
- Safety rating(s): CAT II 1000V, 3A
Close
Fluke TP1 Slim Reach Test Probes
Features
- One pair (red, black) of slender probe bodies for probing closely spaced or recessed terminals
- Hard stainless steel probe tips
- Flat blade design to hold securely in blade type electrical wall sockets
- CAT II 1000V, 10 A rating
Close
Fluke TL26A Test Lead Set
Product Features:
- U-shaped nose for blade-shaped terminals
- Notched jaw for gripping screw heads, bare wire or terminals
- Serrated teeth for gripping threaded or wire-wrapped terminals
- Cluster of sharp needles for piercing small gauge wires (#22-#28 AWG)
- Large piercing needle for penetrating larger gauge wires
Close
Fluke TL175 TwistGuard Test Leads
Features
- Extra-heavy duty strain relief on probe and plug
- Tested beyond 30,000 bends without failure
- -4 to 131°F (-20 to 55°C) operating temp
- Altitude of 6562ft (2000m)
- CAT II 1000V, CAT III 1000V, CAT IV 600V rated
- 10A max, Pollution Degree 2
- Conforms to EN61010-031
- 1-year warranty
Close
Fluke TP4 Slim Reach Test Probes
Features
- One pair (red, black) of slender probe bodies for probing closely spaced or recessed terminals
- Hard stainless steel probe tips
- 0.16″ (4 mm) diameter probe tip designed to fit securely into IEC electrical wall outlets
- CAT II 1000 V, 10 A rating
