Previous product
Back to products
Fluke Amprobe DC205C Deluxe Hard Shell Case
$122.00
Excluding GST 10%
Next product
Fluke Amprobe DL248D Test Leads
$190.00
Excluding GST 10%
Fluke Amprobe DGC-1000A Clamp Ground Resistance Tester
$4,801.00Excluding GST 10%
- Accurate ground resistance measurement from 0.025 to 1500 Ohms
- True-rms current measurement including leakage current
- Accurate readings regardless of power quality in less than 10 seconds
- Continuity beep if the resistance is lower than 40.00 Ohms
- Simple and easy to use, no test leads or auxiliary electrodes necessary
- Data logging capability – 116 records
- Individual data point recording
- User selectable high low ohm audible alarms
- Auto power off (can be disabled)
- Low battery indicator
- Large LCD display
Available on backorder
Related products
Close
Fluke Amprobe 15XP-B Digital Multimeter VolTect
- Features
- The 15XP-B is the right choice for electronics engineers, technicians and field service
- Autoranging display for faster measurements
- TTL logic test for digital circuits
- Integrated tilt stand for easy bench use
- Diode test for component level troubleshooting
- Data Hold freezes display to “hold” measurement reading
- 750 V AC / 1000 V DC—highest voltage rating in this size of meter
- Special 2000M Ω measurement range
- Battery Life: 200 hours typical with carbon-zinc
- Size: (H x W x D) 155 mm x 72 mm x 32 mm (6.1 x 2.83 x 1.26 IN)
- Safety: CAT II 1000V, CATIII 600V, CE, N10140
Close
Fluke Amprobe ACD-6 PRO Digital Clamp Meter 600 V AC/DC
-
Product Features:
- AC current to 1000A
- AC and DC voltage to 600V
- Resistance
- Continuity beeper
- Diode test
- Relative zero mode
- Auto and manual ranging
- Auto power off
- Data hold
- Large, easy to read LCD display
- Accommodates conductors up to 1.77″ (45mm) in diameter
Close
Amprobe ALC-110 Leakage Current Clamp
-
Product Features:
- Measures:
- Earth and differential leakage currents
- Leakage currents through the earth (PE) conductor
- Appliance current consumption without interruptions to the circuit
- Low influence of external low frequency magnetic fields: @ IN: 3.500 mA – 600.0 mA ≤ 30 A/m, operating class 2
- True-RMS measurements for accuracy when measuring complex, non-sinusoidal waveforms
- Mechanical jaw lock with 1.2 in. (30 mm) opening assures accuracy of low current measurements
- Highest resolution of 0.001 mA while measuring up to 60 A
- Broad frequency range 15 Hz to 1 kHz
- Selectable filters:
- Low Pass 50/60Hz filter to perform measurements on equipment driven by Variable Frequency Drives (VFDs) or affected by high frequency noise
- Appliance Filter to conduct leakage current measurements on appliances
- No filter
- Selectable limits: 0.25 mA, 0.5 mA, 3.5 mA, 10 mA, 12 mA
- Max readings and hold function
- High safety rating: CAT III 600 V
- Battery-saving design with an auto backlight off and auto power off
Applications
- Trace the source of earth leakage current
- Identify intermittent GFCI trips without switching equipment off
- Check a system for an electrical break of insulation where current is flowing to the ground
- Where industrial leakage current testing is required
- Measures:
Close
Fluke Amprobe AM-140-A Precision TRMS Digital Multimeters with PC Connection
- Features
- True RMS (TRMS)
- Measurements: Voltage up to 1000V AC/DC, Resistance, AC/DC Current, Frequency, Capacitance, Duty Cycle
- Optical isolated PC interface capability
- Crest (Peak hold), MAX, MIN MAX-MIN recording
- Auto and manual ranging
- Intelligent auto power off
- Data hold
- Relative zero mode
- Audible and visual warning against improper plug-in
- DC Loop Current 4-20mA
- dBm reading with 20 selectable impedance values
- Backlight display
- Large, easy to read large LCD display
- High speed analog bar graph
- Diode Test
- 4-20mA DC loop current
- Audible continuity
- Safety CAT IV 600V, CAT III 1000V
Close
Fluke Amprobe 33XR-A Digital Multimeter with Temperature
-
Product Features:
- Frequency To 40 MHz, Temperature To 1832 F, Capacitance To 4000 microF
- Input Warning Tone When Test Leads Are In Wrong Jack
- 1000V/750V DC/AC
- 10 Amps AC/DC. Fully Safety Fused
- Resistance To 4ohm
- Min/max, relative, peak and data hold
- Auto power off to save battery life
- Separate door for easy battery and fuse access
- Magne-Grip Holster with magnetic hanging strap
- Display: 3-3/4 digit LCD, 3999 counts with 41-segment analog bar graph
- Display update rate: 2/sec, nominal
- Analog bar graph
- Overrange indication
- Operating temperature: 0 °C to 45 °C at < 70 % R.H.
- Storage temperature: -20 °C to 60 °C,
- Input warning tone when test leads are in wrong jack
Close
Amprobe AC50A AC Leakage Clamp Meter
-
Product Features:
- AC current measurement to 60A
- Leakage current measurement with resolution of 0.01mA
- AC voltage to 400V
- Resistance measurement and continuity beeper
- Min/max control to see largest or smallest values in series of measurements
- Relative value measurement to determine differentials
- Data hold to freeze measurement value on display
- Digital display with analog bargraph
- Jaw opening: 30 mm (1.2 in)
- Auto-power off to save battery life
- Minimum resolution 0.01mA
Close
Amprobe ACD-10 TRMS-PLUS 600 A Clamp Multimeter
- AC/DC Voltage to 600 V
- AC Current to 600 A
- Thin jaws, only 0.4″ (10 mm) thick
- Resistance to 40 MΩ
- Continuity buzzer
- Capacitance to 3000 uF
- Frequency measurement
- In rush current
- Hold maximum reading functions
- Accommodates conductors up to 1.02″ (26 mm) in diameter
- Auto ranging
- Auto power off
- Rubber over-molded case
- Overload protected
- True-rms measurement
Close
Fluke Amprobe ACDC-52NAV AC/DC CAT IV 600 A TRMS Navigator Clamp Meter
-
Product Features:
- True-RMStechnology improves accuracy in noisy environments
- Measures AC and DC voltage to 1000V
- Measures AC and DC current to 600A
- Resistance, frequency, and capacitance measurements
- Power and power factor, total harmonics distortion (THD) and individual harmonics from 1 to 25
- Includes inrush current measurement and phase rotation indication for 3-phase motors
- Non-contact voltage detection enhances safety
- Low pass filter enables measuring voltage and frequency for variable frequency drives
- Continuity beeper quickly identifies shorts and opens
- Large backlit digital display with analog bar graph presents full picture
- Min, max and smart data hold
- Peak hold identifies spikes and transients
- In-jaw flashlight automatically lights when jaws open, illuminating dark panels and junction boxes
- Auto power off conserves battery life
- Maximum jaw opening accommodates conductors up to 1.45″ (37mm)
- Rubber overmold body absorbs shocks: drop proof to 4 ft. (1.2m)
- Meets CAT IV 600V /CAT III 1000V safety standards
